mam nove ramky (CORSAIR DDR2 2x512MB 675MHz TWIN2X) a tie maju ist na 4-4-4-12. dal som cpu-z a ten pise ze idu na 5-5-5-15, tak som pozrel do biosu a tam bolo vsetko na AUTO. Dram Cas# latency som dal na 4 ale neviem pod cim su tie ostatne cisla lebo nazvy niesu ako v cpu-z tak sa sem obraciam po radu.
tu su moznosti z biosu:
dram to Cas# latency -nastavil som uz na 4.
dram bank interleave 2;4;8 way -nastavene auto -cpu-z pise 4 way.
precharge to active(Trp) - 2;3;4;5
active to precharge(Tras) - 5 az 19T
active to cmd(Trcd) - 2 az 5T
ref to act/ref to ref(Trfc) - 8 az 22T
act(0) to act(1)(Trrd) - 2 az 5T
read to precharge(Trtp) - 2;3T
write to read cmd (Twtr) - 2;3T
write recovery time(Twr) - 2 az 5 T
dram command rate - nastavil som na 1T ale cpu-z pise 2T
ako to mam nastavit na najlepsiu konfiguraciu alebo aspon aby isli na 4-4-4-12?
pomoc pri nastaveni pamati v biose
4-4-4-12 (CAS# latency - RAS# to CAS# delay - RAS# precharge - RAS# active time)
cize mas tam to prve: CAS LATENCY (Tcl) - (4)
dalej druhe: ACTIVE TO CMD (Trcd) - (4)
tretie: PRECHARGE TO ACTIVE (Trp) - (4)
stvrte: ACTIVE TO PRECHARGE (Tras) - (12)
vsetko ostatne mozes nechat na auto lebo nevies ake by mali byt defaultne hodnoty. a ak ti vsetko pojde tak nemas problem potom.
cize mas tam to prve: CAS LATENCY (Tcl) - (4)
dalej druhe: ACTIVE TO CMD (Trcd) - (4)
tretie: PRECHARGE TO ACTIVE (Trp) - (4)
stvrte: ACTIVE TO PRECHARGE (Tras) - (12)
vsetko ostatne mozes nechat na auto lebo nevies ake by mali byt defaultne hodnoty. a ak ti vsetko pojde tak nemas problem potom.
NB Acer Aspire 3810T